AnchorFix‑1 (300 mL) – Fast-Curing Anchoring Adhesive

AnchorFix‑1 is a high-performance, two-component, fast-curing anchoring adhesive designed for structural applications in uncracked concrete, masonry, natural stone, and rock. It’s an ideal solution for professionals needing secure anchoring of rebars, threaded rods, bolts, and specialized fasteners. Polymerized through a convenient static mixer nozzle, AnchorFix‑1 delivers secure, non-sag bonding—even in overhead installations.

• Rapid Cure Times — Achieves a firm hold in just 35–50 minutes (20–30 °C); faster at higher temps, slightly longer in cold conditions
• Styrene-free Polyester Resin — Low-odour formulation safe for use in confined spaces
• High Load Capacity — Outstanding strength; surpasses concrete in many applications
• Versatile Application Temperatures — Cures from –10 °C to +40 °C; cartridges must be between +5 °C and +40 °C
• Non‑Sag & Overhead Ready — Thixotropic formula with 3 mm max layer thickness; ideal for vertical or ceiling mounting
• Compatible with Standard Caulk Guns — Fits 26:1 thrust ratio guns; effortless application
• ETA-Certified (ETAG 001 Annex 1 & 5) — Conforms to EU standards for structural anchoring in non-cracked concrete
• Heat Resistance — Stable long-term up to +50 °C; short-term exposure tolerates +80 °C
• Anchoring reinforcements, rebars, threaded rods, bolts
• Securing railings, brackets, machinery mounts
• Suitable for concrete, masonry (solid/hollow), natural stone, and solid rock

• Surface Preparation: Drill hole to correct depth/diameter, clean thoroughly with blown air or washer (≥2 cycles). Ensure hole is dry and free of debris .
• Cartridge Prep: Warm cartridge to ≥+5 °C. Unscrew cap, puncture internal seal, attach static mixer, and begin dispensing. Discard first few pushes to ensure uniform mix
• Injection & Insertion: Inject resin from bottom to fill hole; insert anchor slowly, twisting to expel air. Observe open-time limits.
• Curing & Loading: Let cure fully before loading: 35–50 min typical; longer delays for colder temperatures.

• Pack Size: 300 mL cartridge (10.1 fl oz)
• Density: ~1.63 kg/L
• Compressive Strength: ~60 N/mm² after 7 days (@ 20 °C)
• Compressive Modulus: ~3500 N/mm² after 7 days
• Flexural Strength: ~28 N/mm² after 7 days
• Tensile Strength: ~12 N/mm² after 7 days
• Tensile Modulus: ~4500 N/mm²
• Glass Transition Temp.: +60 °C
• Ambient Application Range: –10 °C to +40 °C
• Cartridge Application Range: +5 °C to +40 °C
• Open Time (Tgel): 4–6 min at 20–30 °C; up to 18 min at +5 °C
• Full Cure: 35–85 min (warmer climates); up to 24 hours below 0 °C

• Shelf Life: 12 months, unopened, stored between +5 °C and +25 °C; avoid direct sunlight
• Safety: Refer to Safety Data Sheet for health precautions; keep out of reach of children .